Chapter 4 App Tutorials
WX Series User’s Guide
42
10 After the WIFI LED turns steady green or fast blinking, wait for up to 2 minutes. The POWER LED should start
blinking. The PO WER and Link LED will turn solid green if the pairing process is successful. You can also
check the result on the app screen.
11 Click Do ne to finish the pairing process. The Mpro Mesh Router (the controller) will undergo an auto -
configuration after a Mesh network is established. (See
Section 1.2 on page 13 for more information.)
Check the status of your MPro Mesh network on the Ho m e screen.
12 The PO WER LED shows if the WX Device is ready to join the WiFi network. The LINK LED shows the WiFi link
quality. See
Section Table 12 on page 43 for more information on LED behaviors.
To Next Page
Loading...
