Chapter 4 App Tutorials
WX Series User’s Guide
49
8 Click Do ne to finish the pairing process. The WX Device-1 (the controller) will undergo an auto -
configuration after a Mesh network is established. (See
Section 1.2 on page 13 for more information).
Check the status of your wireless Mesh network on the Ho m e screen.
Successful pairing
9 The PO WER LED shows if the WX Device-2 is ready to join the WiFi network. The LINK LED shows the WiFi link
quality. See Section Table 13 on page 49 for more information on LED behaviors.
10 Now you can connect your WiFi clients to your wireless Mesh network. To do this, note the SSID and WiFi
key printed on the side label of the WX Device-1 using this SSID.
Table 13 LED Table (for WX Device-2)
LED CO LO R STATUS DESCRIPTIO N
POWER Green On Power is on or the MPro Mesh configuration process is done.
Blinking The WX Device-2 is starting up or under the MPro Mesh
configuration process.
Red On The WX Device-2 detects a system error.
Blinking The WX Device-2 is upgrading firmware
Link (with a
WiFi
connection)
Green On The WiFi connection to the WX Device-1 is good.
Amber On The signal is too strong. We suggest moving the WX Device-2
away from the WX Device-1.
Red On The signal is too weak. Move the WX Device-2 closer to the WX
Device-1.
To Next Page
Loading...
