ZyXEL Communications ZyWALL USG100-Plus - 2.7.4 Setting Up the Policy Route

Chapter 2 How to Set Up Your Network
ZyWALL USG100-PLUS User’s Guide
40
2.7.4 Setting Up the Policy Route
1 Go to the CONFIGURATION > Network > Routing screen and click Add in the IPv6
Configuration table.
2 The Add Policy Route screen appears. Click Create New Object to create an IPv6 address object
with the address prefix of 2003:1111:1111:1::/64.
Select Enable.
Select the address object you just created in the Source Address field.
Select any in the Destination Address field.
Select Interface as the next-hop type and then tunnel0 as the interface. Click OK.