Chapter 2 How to Set Up Your Network
ZyWALL USG100-PLUS User’s Guide
41
2.7.5 Testing the IPv6-in-IPv4 Tunnel
1 Connect a computer to the ZyWALL’s LAN1.
2 Enable IPv6 support on you computer.
In Windows XP, you need to use the IPv6 install command in a Command Prompt.
In Windows 7, IPv6 is supported by default. You can enable IPv6 in the Control Panel > Network
and Sharing Center > Local Area Connection screen.
3 You should get an IPv6 IP address starting with 2003:1111:1111:1000:.
4 Use the ping -6 [IPv6 IP address] command in a Command Prompt to test whether you can
ping a computer behind ZyWALL Y. You should get a response.
To Next Page
Loading...
