2.5 First Startup
When you start the device for the first time, the initial initialisation (longer start) is
performed and indicated by the following LED notification sequence: Red Blue Green
Boot animation on the screen Introductory system screen.
The introductory screen provides essential information for User Manual saving
/reading. Select "Don't show welcome screen and run 2N IP Mobile
®
at next start
instead" to deactivate this screen for future system startups.
Caution
If you do not select the "Don't show welcome screen and run 2N IP
®
at next start instead" option on the welcome screen before Mobile
quitting and then enable the launch after the system 2N IP Mobile
®
startup in the Launcher configuration, the application will not be started
for technical reasons. Therefore, be sure to disable the welcome screen
start to make run automatically after the system startup.2N IP Mobile
®
The table below shows the factory values of relevant device parameters:
Parameter Value
IP address will be assigned by the DHCP server
IP mask will be assigned by the DHCP server
IP gateway will be assigned by the DHCP server
Access password to configuration 2n
Administrator password 2n
Time/weather location Prague, CZ
Stand-by switching time 1 minute
To Next Page
Loading...