2N Indoor Touch 2.0 - Factory Reset

2N TELEKOMUNIKACE a.s., www.2n.cz 25/135
1.
2.
a.
b.
c.
3.1 Factory Reset
Follow the steps below to reset the factory values:2N Indoor Touch 2.0
®
Press the Factory Data Reset button in Settings / Administrator mode – ON /
Backup & reset.
Press and hold the Reset button on the device backside:
Remove the device from the installation holder.
Press and hold the Reset button until the notification RGB LED lights up
(yellow, approx. 10 seconds).
Release the Reset button and follow the instructions displayed.
Caution
You can reset the factory values only if the administrator mode is on.
Factory reset results in a complete deletion of all user data.