Configuration manual for 2N IP intercoms
•
•
•
•
Access Blocking – display the active Access Blocking setting: ON/OFF.
Zonal Code– enter the switch numeric zonal code consisting of two characters at least.
However, four characters at least are recommended.
Virtual Card to Wiegand– select a group of Wiegand outputs to which the Virtual user
card No. shall be sent after successful authentication. Can be combined with any
authentication method, including codes, fingerprints, etc.
Silent Alarm Enabled – a virtual code higher by 1 than the access code is assigned to each
access code and used for silent alarm activation. For example, if the access code is 0000,
then the silent alarm activation code is 0001. It means, for instance, that silent alarm is
0000 for access code 9999 and so on. Set the silent alarm action in the Automation section.
To Next Page
Loading...
