Configuration manual for 2N IP intercoms
•
•
•
•
UDP Unicast Enabled– enable audio/video stream sending via the RTP/UDP. If this mode
is off, the audio/video stream data are sent via the RTP/RTSP only.
Maximum Video Packet Size– set the maximum size of the video packets to be sent via
the RTP/UDP.
Starting RTP Port–set the starting local RTP port in the range of the length of 60 ports to
be used for audio and video transmissions. The default value is 4800 (i.e. the used range is
4800–4859).
Jitter Compenstantion –set the buffer capacity for jitter compensation in audio packet
transmissions. A higher capacity improves the transmission resistance at the cost of a
greater sound delay.
To Next Page
Loading...
