2N IP series - Page 145

Configuration manual for 2N IP intercoms
145 / 282
e.
f.
g.
•
•
Invalid input
Invalid userposition
Switch activation
You can either completely mute the above-mentioned sounds,replace them with one of the ten
predefined sounds, or simply record a sound file of your own into the intercom. The sound file
must have the WAV format and use PCM encoding with 8/16 kHz sampling frequency and 8/16-
bit sample resolution, and the file size may not exceed 256 kB.
Frequency Bits for sample Sound length Quality
16 kHz 16 bit up to 8 s 1 best
16 kHz 8 bit up to 16 s 2
8 kHz 16 bit up to 16 s 3 (not recommended
combination)
8 kHz 8 bit up to 32 s 4 low
You can also play the recorded files via Automation using theAction.PlayUserSoundand,
optionally, with the aid of the intercom speaker and/or directly into the phone call.
List of Parameters
Sound Message Language– Select a language of spoken meassages. If there is a
translation available for a mapped sound, the messagewill be played in specified
language. The language defaults to English or to a language-neutral sound if there is no
translation.
Voice Signaling (for French only)–In order to meet the applicable legislation in French
speaking regions, voice signaling in French is available for handicapped persons for the
following actions: call setup, call connection and door unlocking.