Configuration manual for 2N IP intercoms
•
•
•
•
•
Filter Swaying With Amplitude Less Than– set the minimum amplitude of swaying
objects in relation to the whole camera image width/height that has to be exceeded for
the object to be detected (the setting has no influence on non-swaying objects). The
setting range is 3 to 20 %. The motion must also meet the other conditions set in this
section.
Privacy Masking Enabled – enable privacy masking to mask an image section with the
green color or mosaic.
Masking Mode – set the color / mosaic for the masked area.
Mosaic Cell Size – set the mosaic cell size in the masked area.
Privacy Masking Area – set the privacy masking area position and size.
•
Caution
In ARTPEC-7 equipped devices, moving objects are evaluated even beyond the
active zone including the set filters (if Custom Image Crop is enabled, objects are
evaluated even in the cropped image parts that cannot be seen in the preview).
The objects that enter the active area trigger a detected motion event. For
example, if the time filter is set to 5 s, any object moving beyond the active area for
10 s triggers a detected motion the moment it enters the active area, because it
has met the filter condition beyond the active zone. The object keeps being
detected even if it leaves the active zone and having re-entered the active area, it
triggers the event instantaneously (unless it leaves the camera image area
completely and is 'forgotten').
To Next Page
Loading...
Need help?
General
