EasyManuals Logo

2N IP series User Manual

2N IP series
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #185 background imageLoading...
Page #185 background image
Configuration manual for 2N IP intercoms
185 / 282
2N
®
IP Style Display Backlight Settings
The Backlight and Backlight in Low Power Mode settings are valid for the display and ambient
LED backlight.
Intensity in Active Mode by Day – set the maximum backlight intensity for the daytime
(the value is controlled by the ambient light sensor). Set the value as a percentage of the
maximum possible brightness.
Intensity in Active Mode by Night set the maximum backlight intensity for the night
(the value is controlled by the ambient light sensor). Set the value as a percentage of the
maximum possible brightness.
Current Value –display the current backlight intensity value automatically
selectedaccording to the ambient light level detected.
Note
The intensity brightness parameters affect the function, power consumption and
general appearance of your device. A high nametag and button backlight value
may, if the ambient light level is low, dazzle the persons standing in front of the
intercom and, in general, increase the power consumption of the device. A low LED
intensity value, on the other hand, may, if the intercom is placed in direct sun,
result in a lower LED on/off contrast and potential LED state identification
problems.

Other manuals for 2N IP series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 2N IP series and is the answer not in the manual?

2N IP series Specifications

General IconGeneral
CategoryIntercom System
Network Interface10/100 Mbps Ethernet
ConnectivityEthernet
IntegrationSIP
Ingress ProtectionIP54
Operating Voltage12V DC
Audio CodecG.711
Supported ProtocolsSIP, RTSP, HTTP, HTTPS
Supported LanguagesMultiple

Related product manuals