2N IP series - Page 197

Configuration manual for 2N IP intercoms
197 / 282
•
•
•
•
•
•
•
Display Touch Icon in Showcase Mode – Enable displaying of the touch icon (pulsating
hand) in the Showcase mode.
Display Antibacterial Notification – enable displaying of information on the antibacterial
layer applied to the display (2N® IP Style optional accessory) during the Showcase mode.
Bluetooth Authentication Button Mode – sets whether the Bluetooth authentication is
activated by swipe or just tap. The setting will take effect only once there are no phones
with Mobile Key application in the vicinity of 2N
®
IP Style.
Swipe –swipe the button from left to right to activate the lock.
Tap – tap the button to activate the lock.
Bluetooth Button Location – set the Bluetooth authentication button location. The
setting will take effect only once there are no phones with Mobile Key application in the
vicinity of 2N
®
IP Style.
Background Image – load the background image (to be used for various screens). The file
must be an image with the minimum resolution of 800 x 1280 pixels. Images with higher
resolutions will be reduced in size.
•
•
Caution
The device automatically returns to the display home page in a 60-second idle
time. After that, the countdown of the timeout set in this parameter starts and
then the device goes into the Showcase mode.
After a 2-minute idle time, the screen saver is launched on 2N
®
IP Style, in which
the display brightness value goes up and down alternately in 20-second intervals.
The screen saver mode is terminated by a screen touch, access attempt, incoming
call, notification display or motion detection even in case the motion detection
function is disabled. If the screen saver is running on the background in the
Showcase mode, the termination by a touch also switches the device onto the
home page.
