2N IP series - Page 207

Configuration manual for 2N IP intercoms
207 / 282
•
•
•
•
•
•
Interface Mode – enable the Wiegand function and set Wiegand IN/OUT. The IDs of the
cards tapped on the internal card reader are always resent to Wiegand OUT.
Door –set the reader direction (Arrival, Departure) for the Attendance system purposes.
Received Code Format–set the format for the codes to be received(Wiegand 26, 32, 37
and RAW).
Transmitted Code Format–set the format for the codes to be transmitted(Wiegand 26,
32, 37 and RAW).
Change Facility Code– set the first code part via Wiegand. This applies to Wiegand OUT
for 26-bit code format. Contact your security system supplier to know if the Facility Code is
requested.
Facility Code– define the 2NIP intercom location in the security system. Enter a decimal
value for the location (0–255).