2N IP series - Page 223

Configuration manual for 2N IP intercoms
223 / 282
•
•
•
Transmitted Code Format – set the format for the codes to be transmitted (26-bit, 32-bit,
37-bit and RAW format, 35-bit, Corp. 1000, 48-bit, Corp. 1000 and Auto).
Change Facility Code– set the first code part via Wiegand. This applies to Wiegand OUT
for 26-bit code format. Contact your security system supplier to know if the Facility Code is
requested.
Facility Code –define the2NIPdevice location in the security system. Enter a decimal
value for the location (0–255).