Configuration manual for 2N IP intercoms
•
•
•
•
•
•
•
At Boot Time– enable check and, if possible, update execution upon every intercom start.
Update Period– set the update period. Set an automatic update to take place hourly/
daily/weekly/monthly, or set the period manually.
Update At– set the update time in the HH:MM format for periodical updating at a low-
traffic time. The parameter is not applied if the update period is set to a value shorter than
1 day.
Next Update At– set the next update time.
Last Update At–last update time.
Update Result–last update result. The following options are available:DHCP option 66
failed, Firmware is up to date, Server connection failed, Running..., File not found.
Communication Result Detail– server communication error code or TFTP/HTTP status
code.
Result Description
Invalid server
address
The server address is invalid.
Unsupported
protocol
The protocol is not supported. HTTP(s) and TFTP are supported only.
Invalid file path The provisioning file location is invalid.
To Next Page
Loading...
Need help?
General
