2N IP series - Page 266

Configuration manual for 2N IP intercoms
266 / 282
•
•
•
•
•
•
Communication Result Detail(Common Config)– server communication error code or
TFTP/HTTP status code.
Update Result (Private Config)– private configuration follows the common
configuration update. The device with private configuration is identified by its MAC
address.The last performed private update result is displayed.The following options are
available:DHCP option 66 failed, Firmware is up to date, Server connection failed,
Running..., File not found.
Communication Result Detail(Private Config)–server communication error code or
TFTP/HTTP status code.
My2N / TR069
Use this tab to enable and configure remote intercom management via the TR-069 protocol.
TR-069 helps you reliably configure intercom parameters, update and back up configuration
and/or upgrade device firmware.
The TR-069 protocol is utilised by the My2N cloud service. Make sure that TR-069 is enabled and
Active profile set to My2N to make your intercom log in to My2N periodically for configuration.
This function helps you connect the intercom to your ACS (Auto Configuration Server). In this
case, the connection to My2N will be disabled in the intercom.
My2N / TR069 Enabled–enable connection to My2N or another ACS server.
Active Profile–select one of the pre-defined profiles (ACS), or choose a setting of your
own and configure the ACS connection manually.
Next Synchronisation in–display the time period in which the intercom shall contact a
remote ACS.