2N IP series - Page 67

Configuration manual for 2N IP intercoms
67 / 282
Connecting Time Limit – set the maximum outgoing call connection timeout after which the
calls are automatically terminated. If the calls are routed to the GSM network via GSM gateways,
you are advised to set a value higher than 20 s.
Ring Time Limit – set the outgoing call setup and ringing time limit after which the calls shall be
automatically terminated. If the calls are routed to the GSM network via GSM gateways, you are
advised to set a value higher than 20 s. Minimum value 1 s, maximum value 600 s. Configure 0 to
disable this time limit. Dial Cycles Limit – set the maximum count of user deputy dial cycles if
the user dialled by the Phone Book position number is inaccessible. The function helps you
avoid deadlock if the User Deputy is set to the same value in the Phone Book.Refer to
Subs.5.4.1.1 Calling Cycle Limitfor calling cycle limit settins options.
End Group Calls at First Rejection – enable the device to end all outgoing group calls if any of
the called destinations rejects the call.
Calling Virtual Numbers– allow the calling of preset virtual numbers of users.
Floor/Apartment Dialing Mode – enable the special Floor/Apartment dialling mode. In this
mode,enter the assigned user virtual number via the numeric keypad. Available for
model2N
®
IP Vario only. Enter the floor/apartment code to the user Virtual number. The code
may include digits and letters A–F.Telephone Mode Enabled–enable the option to set up calls
directly to the phone numbers dialed via the intercom numeric keypad. Enter the phone number
key sequence to set up the call.
•
Tip
Set up a call to2N
®
IP Forceand2N
®
IP Varioas follows: press phone_number
(or phone_number for2N
®
IP Verso). If you do not press (or
for2N
®
IP Verso) as the terminating character, the dialling will be confirmed
automatically when the code entering timeout expires as if (or for2N
®
IP
Verso) was pressed.
