Configuration manual for 2N IP intercoms
•
•
•
•
Example 1
The algorithm first resolves the branches independently of each other. There are users Alice and
Carol configured to one button in the example below (by pressing the button two parallel calls
are initiated together). The Dial Cycles Limit is set to 2. Alice has two phone numbers (calling
destinations), the other users have only one calling destination. The deputies are configured as
follows:
Alice is the deputy of Bob
Bob is the deputy of Alice
Carol is the deputy of Dave
Dave is the deputy of Carol
The resulting calling scheme looks like this (in case no one picks up or rejects the call):
To Next Page
Loading...
