2N IP series - Page 78

Configuration manual for 2N IP intercoms
78 / 282
•
•
•
•
•
•
Authentication ID – enter the alternative user ID for the device authentication. Phone
Number (ID) will be used if this parameter is left empty.
Password– enter the password for authentication. The parameter is applied on if your
PBX requires authentication.
Proxy Address– set the SIP Proxy IP address or domain name.
Proxy Port
*
– set the SIP Proxy port. The device uses the default port according to the
transport layer (5060 or 5061) or a port obtained from DNS in case the parameter is empty
or set to 0.
Backup Proxy Address– set the SIP Proxy IP address or domain name to beused where
the main proxy fails to respond to requests.
Backup Proxy Port
*
– set the backup SIP Proxy port. The device uses the default port
according to the transport layer (5060 or 5061) or a port obtained from DNS in case the
parameter is empty or set to 0.