Configuration manual for 2N IP intercoms
•
•
•
•
•
•
•
•
Registration Enabled– enable intercom registration with the set SIP Registrar.
Registrar Address– set the SIP Registrar IP address or domain name.
Registrar Port
*
– set the SIP Registrar port. The device uses the default port according to
the transport layer (5060 or 5061) or a port obtained from DNS in case the parameter is
empty or set to 0.
Backup Registrar Address– set the SIP registrar IPaddress or domain name to be used
where the main registrar fails to respond to requests.
Backup Registrar Port
*
– set the backup SIP registrar port. The device uses the default
port according to the transport layer (5060 or 5061) or a port obtained from DNS in case
the parameter is empty or set to 0.
Registration Expires– define the registration expiry, which affects the network and SIP
Registrar load by periodically sent registration requirements. The SIP Registrar can modify
the expiry limit without letting you know.
Registration State–display the current registration state(unregistered, registering...,
registered, unregistering...).
Failure Reason–display the reason for the last registration attempt failure: the last error
reply of the registrar, e.g. 404 Not Found.
•
Tip
To set the Outbound Proxy complete the Outbound Proxy address into the Proxy
address and Registrar address parameters. Domain = Registrar address.
•
Caution
If the parameter
*
is empty or set to 0, the default port is used according to the
selected transport protocol (5060 for TCP or UDP, 5061 for TLS).
To Next Page
Loading...
Need help?
General
