DUA1640-5AAA02
Rack and Wall Mounting 3-9
Wall Mounting
You can wall mount up to two hubs.
To fit the brackets to one hub, for wall mounting:
1
Place the hub the right way up on a hard, flat surface with the front
facing towards you.
2
Locate a mounting bracket over the mounting holes on one side of the
hub, as shown in Figure 3-3.
Figure 3-3
Locating the Brackets for Wall Mounting One Hub
3
Insert the two screws and fully tighten with a suitable screwdriver.
4
Repeat the two previous steps for the other side of the hub.
To fit the brackets to two hubs, for wall mounting:
1
Stack the hubs the right way up on a hard, flat surface with the front
facing towards you.
2
Locate two mounting brackets over the mounting holes on one side of
the hubs, as shown in Figure 3-4.
To Next Page
Loading...
