DUA1640-5AAA02
Unit Pages 7-11
Unit Status
This page provides detailed information about the unit:
Unit Name
The name configured for the stack.
Location
Where the stack is located.
Contact
The person to contact if there is a problem with the stack.
The Unit Name can be configured using the System Name page (in the
Management Settings category), refer to “System Name” on
page 7-19
.
The Location and Contact can be configured using Quick Config
Manager or an SNMP network management application.
Unit Description
The unit’s product name.
Hardware Rev
The version of hardware inside the unit.
MAC Address
The unit’s MAC (Ethernet) address.
Software Version
The version of management software that the unit
is running.
Boot PROM Version
The version of software on the Boot PROM inside
the unit.
Unit Uptime
The time that has elapsed since the unit was last reset,
initialized or powered on.
Unit Attention Light
A checkbox for you to light the Attn LED, to
help identify the unit in the stack.
To display the Management Addresses page, click
IP Setup
at the
bottom of the Unit Status page.
To Next Page
Loading...
Need help?
General