I
MPORTANT
S
AFETY
I
NFORMATION
WARNING: Warnings contain directions that you must follow for your
personal safety. Follow all instructions carefully.
Please read the following safety information thoroughly before
installing the PS Hub.
■ Installation and removal of the unit must be carried out by qualified
personnel only.
■ Connect the unit to an earthed power supply to ensure compliance
with European safety standards.
■ The power cord set must be approved for the country where it will
be used.
■ The appliance coupler, that is, the connector to the device itself and
not the wall plug, must have a configuration for mating with an
EN60320/IEC320 appliance inlet.
■ For U.S.A. and Canada:
■
The cord set must be UL-approved and CSA certified.
■
The minimum specification for the flexible cord is:
No. 18 AWG
Type SV or SJ
3-conductor
■
The cord set must have a rated current capacity of at least 10A.
■
The attachment plug must be an earth-grounding type with a
NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A, 250V)
configuration.
■ For Denmark:
■
The supply plug must comply with section 107-2-D1, standard
sheet DK2-1a or DK2-5a.
To Next Page
Loading...
