3Disc FireCR+ User Manual

Service Manual
FireCR+ Computed Radiography Scanner
Doc No.: TM-812
Rev: Aug 2013
Part No.: CR-FPM-01-003
3DISC, FireCR, Quantor and the 3D Cube are trademarks of 3D Imaging & Simulations Corp, South
Korea, and its affiliates. All other trademarks are held by their respective owners and are used in an
editorial fashion with no intention of infringement. The data in this publication are for illustration purposes
only and do not necessarily represent standards or specifications, which must be met by 3D Imaging &
Simulations Corp. All information contained herein is intended for guidance purposes only, and
characteristics of the products and services described in this publication can be changed at any time
without notice. Products and services may not be available in your local area. Please contact your local
sales representative for availability information. 3D Imaging & Simulations Corp. strives to provide as
accurate information as possible, but shall not be responsible for any typographical error.
© Copyright 2013 3D Imaging & Simulations Corp, all rights reserved, printed, and published in South
Korea by 3D Imaging & Simulations Corp.

3Disc FireCR+ Specifications

General

Brand	3Disc
Model	FireCR+
Category	Scanner
Language	English

Summary

FireCR+ Components Overview

Recommended Computer Requirements

Specifies the minimum hardware and software requirements for operating the FireCR+ scanner.

FireCR+ Installation Guide

Table Top Installation

Instructions for placing and stabilizing the scanner on a flat surface.

Wall Mount Installation

Steps for securely mounting the scanner to a wall using brackets.

System Connections

Guidance on connecting power supply and USB cables to the scanner.

Cassette and IP Inspection

Procedures for inspecting cassettes and imaging plates for defects or damage.

FireCR+ Calibration Procedures

Calibration Geometry Explained

Illustrates the required X-ray beam coverage for calibrating the scanner.

Calibration Procedure Steps

Detailed steps for performing the calibration process using the software interface.

Understanding Calibration Files

Explanation of calibration files and how to interpret them for quality assessment.

FireCR+ Reader Diagnostics

Scanner Control Interface

Overview of the scanner control panel functions and parameters.

Diagnostics Window Explained

Description of the diagnostics window gauges and their meanings for system health.

FireCR+ Parts Removal and Replacement

Removing the Top Cover

Instructions on how to safely remove the scanner's top cover.

Removing the Internal Cover

Steps for removing the scanner's internal cover after the top cover.

Replacing the Main Board

Procedure for removing and replacing the main circuit board.

Replacing the Core Board

Procedure for removing and replacing the core circuit board.

Replacing the BLDC Board

Steps for removing and replacing the Brushless DC motor control board.

Replacing the Cassette Lock Motor Board

Procedure for removing and replacing the cassette lock motor control board.

Replacing the Optic Plate

Steps for removing and replacing the scanner's optic plate assembly.

Replacing the Aligner Motor

Procedure for removing and replacing the aligner motor.

Replacing the Y-Axis Motor

Steps for removing and replacing the Y-axis motor.

Replacing the Fiber Bundle

Procedure for removing and replacing the fiber optic bundle.

Replacing the Internal Frame

Steps for removing and replacing the scanner's internal frame structure.

Replacing the RFID Board

Procedure for removing and replacing the RFID board.

Replacing the Power Board

Steps for removing and replacing the scanner's power board.

FireCR+ Troubleshooting Guide

Image Quality Artifacts

Identifies common image artifacts and their causes/solutions.

Mechanical Noise Issues

Addresses causes and solutions for mechanical noises like belt jumping or unaligned stages.