3M Clean-Trace Luminometer LX25 - Home Screen; 1. Flexible Endoscope Workflow

10
Home Screen
• Shows recentaudits
• Use the arrow in the gray bar to
toggle between a list of “Recent
audits” and “Recent failed audits”
The 3M™Clean-Trace™ Luminometer LX25 has a unique
workflow for each application. Please choose the appropriate
application and follow the screen prompts. All available
application workflow are outlined below.
1. Flexible Endoscope Workflow
2. Environmental Surfaces Workflow
3. Surgical Instrument Workflow
1. Flexible EndoscopeWorkflow
• From the Home screen tap “Start”
to begin new test or select a
recent failed audit for retest
• Select device type
• Select Device. This is the serial
number or other unique identifier.
• Select “Reprocessing Step”
• Review selections
o
Select technician.
o
Can change device,
reprocessing step and test plan
o
Tap “Perform Audit”
• Select test point
• Review selections
• Insert ATP Test
• Press “Begin Measurement”
and wait until blue “Reading
Result” screen disappears then
press“Return”
• Repeat process until all test points
have been tested. Press “Done”.