3M Clean-Trace Luminometer LX25 - 3. Surgical Instrument Workflow; Performing a Retest

12
3. Surgical InstrumentWorkflow
• From Home screen select“Start”
• From select “Test Plan” screen,
select “RoutineAudit”
• Review selections then select
“Performaudit”
• Selectinstrument
•Reviewselection
• Insert ATP Test UXC or H2O
• Press “Begin Measurement”
and wait until blue “Reading
Result” screen disappears then
press“Return”
• Repeat process until all test points
have been tested. Press“Done”.
Performing aRetest
To retest a failed test point:
• From the home screen, select
the audit that requires retesting;
marked with a red “X”.
• Select the test point that requires
retesting; marked with a red “X”.
• Follow the prompts and select any additional test points
if required.
• Complete the retest
• Select “Done”
• All retest data is recorded on the Clean-Trace
Luminometer LX25 and in QCDM.