Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to avoid danger or
property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
WARNING: Serious injury or death may be caused if any of these warnings are neglected.
CAUTION: Injury or equipment damage may be caused if any of these cautions are neglected.
WARNINGS:
Please adopt a power adapter which can meet the safety extra low voltage (SELV) standard
when possible, and source with 12 VDC or 24 VAC (depending on models) according to the
IEC60950-1 and Limited Power Source standard. Before applying power to the camera,
check the power source to ensure that it is within the specifications
If the product does not work properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the camera yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or maintenance.)
To reduce the risk of fire or electrical shock, do not expose this product to rain or moisture
unless it is an exterior/weatherproof model. Please do not install the camera in a place
exposed to direct sunlight. Do not operate the camera in environments beyond the
specified temperature. Refer to your specific camera model’s section of this manual for
environmental conditions and limitations.
This installation should be made by a qualified service person and should conform to all the
local codes.
Please install blackout equipment into the power supply circuit to prevent footage and
data loss.
Please make sure that the ceiling can support more than 50(N) Newtons of gravity if the
camera is fixed to the ceiling.
To Next Page
Loading...
Need help?
General
