12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
6.4.6 MAIN UNIT INSTALLATION
The main unit can be mounted on the installation surface by the built-in slide plates.
Steps:
1). Pull out both slide plates at the bottom of the main
unit.
2). Place the main unit on the installation surface by
facing the bottom of the main unit toward the
installation surface, and mark the drilling spots based
on the alignment holes on the slide plates.
3). Drill the marked spots with a screw driver.
To Next Page
Loading...
