A&D EJ-303 - Breeze Break (for the EJ-123; EJ-303)

11
4.3. Breeze Break (For the EJ-123 / EJ-303)
The breeze break can prevent a measurement error due to a (disturbing) wind.
The clear cover can be disconnected from the fixing frame easily when adding an
excessive stress during operation. Assemble the breeze break with the following steps.
Assembling the Breeze Break
1. Slide back the fixing frame to
attach the breeze break.
(Or install the fixing frame into the
guide on the balance.)
2. Attach the axis of the breeze
break on the groove of the fixing
frame when keeping the angle of
90 degrees.
3. Slide and fix the breeze break.
4. Close the breeze break.
Pivot axis
Fixing frame
Breeze break
Step 1
Step 3
Step 2
90°
Step 4
Breeze break
Hook
Hook
Groove
Guide
Guide