Ascotel® IntelliGate® 150/300 as of I7.9
150 Configuration
syd-0210/1.7 – I7.9 – 12.2009
Upload
During an upload via the AIMS Shell the PBX data are written from the AIMS data-
base into the PBX.
During a data upload the PBX is automatically prebarred and then again released
once the operation is completed. The progress of the upload operation is indicated
by a progress indicator bar in a window.
The status of CFUs, user group members, switch groups and relays can also be up-
loaded.
An upload is carried out in the following cases:
• Putting a new system into operation.
• Restoring a system if the configuration has been lost.
• Replicating a special configuration, e.g. copying customer data to a different sys-
tem.
Note:
Some configuration changes only take effect after a restart. Once the
upload is completed, the system asks whether the PBX should be
restarted.
Partial Upload
The Partial Upload function is used to load the following data individually from the
AIMS database to the PBX.
• Abbreviated dialling numbers
• PISN user data
• Terminal data (individual or block by block)
• LCR (Least Cost Routing) data
• AIP data
With a partial upload, configuration data that changes frequently can be trans-
ferred more quickly into the system.
Note:
A partial upload is only followed by a restart and disconnection of exist-
ing phone connections if system data is loaded up onto a PBX. In this case
the system generates an appropriate message.
To Next Page
Loading...
