Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range 05/2008 Page 5-49
5.6.4 Installation
5.6.4.1 Connections
Refer to the network connection diagram in section 12.2.3.
If required, refer to the mains connection diagram, section 12.2.4.
5.6.4.2 Connection
To the LAN: using a Ethernet cord not supplied (remote supply possible via the LAN).
Set of 10 Ethernet cables:HT1455A.
To the telephone handset: by a coiled cable with an RJ9 type male connector at each end.
To the headset: see Section 12.3.1.
To the mains: using a power supply unit (PN1120A) if power is not remotely supplied to the set via
the LAN.
5.6.4.3 Default settings on delivery
Key sound :Yes Level :4
Ring: 4 Level:4
Handset volume Level :5
Speaker volume Level :6
Headset Microphone volume Level :5
Keypad:-Qwerty (English + others)
-Azerty (French + French-speaking countries)
Direct call: Int.
Display:-Contrast: 8
-Saver timeout: 15 min.
To Next Page
Loading...
