AMT/PTD/TR/0001/3/7/EN Installation Manual for digital sets - IP sets - SIP sets
Page 5-2 05/2008 To install sets and cartridges in the i7XX range
5.1.2.2 Access to the i740/i740N configuration
An initialisation phase is activated on power up. When initialisation is complete, a question mark
appears on the left of the display.
The installer then has 5 seconds to enter one of the following sequences:
*
1
("Prog"*1) to enter network parameters in the configuration menu, the first menu option
"Phone number" is displayed.
The password is the set's release code (default value 0000).
or
*
7
("Prog"*1) to enter Ethernet parameters in the configuration menu, the first menu
option, "AutoNegotiation", is displayed.
Available
i740/i740N: commands
: Next option
: Previous option
: Exit and validate programming
: Clear (one character at a time, from right to left)
: Manually enter the IP address dot
: Exit without validating programming
: Select entry field
To Next Page
Loading...
