Product Guide - A5000 R5.4 – Aastra X series
BPS0121AENAA01 Page 73/74
5.9.1 Automatic restart
Automatic restart of the system
The Aastra X series restart time depends on the number of installed cards. Measurements have been
performed on the Aastra X series in order to determine the maximum reloading and restart time: 2
minutes 30 seconds.
For an AXD:
• The duplex switchover is around 40 seconds (MMI recovery, tone on traditional sets included)
• The time to detect a problem on a RUCV card (in one of the expansion cabinets) is around 2
minutes
• The time taken to switch over to duplex mode after a problem occurred in an expansion
cabinet is around 2 minutes 40 seconds (MMI recovery, tone on traditional sets included)
5.9.2 Backup and restitution duration
The backup and restitution duration explained below are the results of in-lab- tests with an average
configuration on AX Series:
• Configuration Backup: depending on the site’s size from 5mn to 15mn
• Configuration Restitution: depending on the site’s size from 5mn to 15mn
• Reset: simple reset lasts 60 seconds, OS reset lasts220 seconds
• Restart of the « by default » configuration: Reinstallation of « Total » mode configuration. : 5
minutes
+ OS restart of 220 seconds (+ 5 minutes before accessing on AMP).Don’t forget the
additional 60 seconds needed for the additional reboot mandatory to validate the test
partition
• Restart of a customer’s configuration: Same procedure as the « by default » but an additional
duration could depend on the customer’s data (i.e. depends on the site’s size).
5.10 Power consumption of Cards and motherboards
Please refer to Chapter 10.
To Next Page
Loading...
