ABB A140-H55 - Removing the Cartridge Group

Operation Manual / 4 Product description / A130-H.. - A140-H..
8
Dismantling and fitting
Page 83 /
115
© Copyright 2015 ABB. All rights reserved.
HZTL4030_EN
Revision C
September 2015
8.8 Removing the cartridge group
Figure 34: Removing insulation sheets
 If present: Remove the insulation sheets (01, 02, 03).
NOTICE
Marking casing position for assembly
ABB Turbo Systems recommends marking the casing positions prior to
disassembly.
Do not remove oil orifice (if present)
To limit the oil flow rate through the bearing casing during operation (engine under load) to the
admissible values, an oil orifice is mandatory at the oil inlet of the bearing casing if the oil inlet
pressure is > 3 bar (overpressure).
If an oil orifice is fitted in the oil inlet of the bearing casing, it must not be removed.
Figure 35: Oil orifice
01
Bearing casing
02
Oil orifice
03
Circlip