ABB A140-H55 - Table 41 Tightening Torque (72011)

Operation Manual / 4 Product description / A130-H.. - A140-H..
8
Dismantling and fitting
Page 94 /
115
© Copyright 2015 ABB. All rights reserved.
HZTL4030_EN
Revision C
September 2015
Installing the compressor casing
Figure 48: Installing the compressor casing
Part number
A130
A135
A140
72011 M8
35 Nm
M10
70 Nm
M12
105 Nm
Table 41: Tightening torque (72011)
 Always replace the O-ring (42012) (see chapter Spare parts).
1. Thoroughly clean the fastening strips (72012) before assembly.
2. Attach swivel lifting eyes (01) to the compressor casing (72000) and lifting gear.
3. Install the compressor casing (72000).
4. Install the fastening strips (72012) with screws (72011).