ABB A140-H55 - Table 3 Requirements for Threaded Rods

Operation Manual / 4 Product description / A130-H.. - A140-H..
2
Removing and Installing
Page 17 /
115
© Copyright 2015 ABB. All rights reserved.
HZTL4030_EN
Revision C
September 2015
2.3.2 Fitting threaded rods
Figure 10: Inserting the threaded rods
1. Lightly oil the surfaces of the threaded rods (02) to be screwed in.
2. Screw the threaded rods into the bracket with the aid of locknuts (01).
3. Remove nuts (01) again.
Requirements for the threaded rods
Figure 11: Requirements for threaded rods
Product
Diameter
Threaded rod
[mm]
Material
DIN / ISO 898
(Part 1)
Thread
length
L1 [mm]
Length of threaded rod
Oil-cooled
L2 [mm]
Water-cooled
L2 [mm]
A130 Ø 16 / M16 10.9 / 12.9 ≥ 30 250 250
A135 Ø 20 / M20 10.9 / 12.9 ≥ 30 270 325
A140 Ø 24 / M24 10.9 / 12.9 ≥ 70 350 … 360 410 … 420
Table 3: Requirements for threaded rods
Fixing material scope of delivery
The threaded rods and nuts for fastening the turbocharger on the bracket are not included in
the ABB Turbo Systems scope of delivery. These parts depend on the version of the engine-
side bracket.
The clamping nuts are included in the ABB Turbo Systems scope of delivery.