ABB A170-M Series - Fig. 37: Removing Wall Insert; Removing the Compressor Casing

To Next Page

To Previous Page

Operation Manual / A170-M.. - A175-M..

9 Disassembly and assembly / 9.5 Removing the compressor casing

9.5 Removing the compressor casing

Removing wall insert

Fig.37: Removing wall insert

1. Loosen screws(72011) and remove with washers(72008).

2. To secure the wall insert, screw in one screw(72011) a third of the way.

3. Press off wall insert with three screws(72011) until the lifting device(90190) and the fix-

ing segment(90192) can be fitted.

4. Fit the lifting device(90190) and the fixing segment (90192) to the flange of the wall in-

sert (77000) using the screws (90197) and washers(90198).

Depending on the hole pattern of the wall insert (77000), the screws (90197) cannot be

fitted symmetrically.

5. Put on shackle(90195) and fasten to lifting gear.

6. Remove locking screw(72011).

Page 82 / 146

Other manuals for ABB A170-M Series