LED State Color LED = ON LED = OFF LED flashing
Slow flashing
(1 Hz):
The firmware
update from
the memory
card has been
completed
successfully
or
Boot project is
being
updated.
Slow flashing
(0.5 Hz)
together with
MOD1 LED
ON:
Mode1: Boot
project is not
loaded.
Two LEDs
below “ERR”
and “MOD1”
Configurable Yellow Configurable Configurable Additional two
LEDs are
reserved and
can be con-
trolled from
IEC user code
with FB
PmLedSet
The AC500-eCo V3 processor module also provides 2 LEDs below the state LEDs which can
be used by user and driven by an application.
The LEDs can be used into a project and controlled using special function blocks which are con-
tained in the PM AC500 library. The POU is PmLedSet located in folder LED control.
The processor module provides up to 10 LEDs (PM5012-x-ETH), 20 LEDs (PM5032-R-ETH,
PM5052-R-ETH), or 22 LEDs (PM5032-T-ETH, PM5052-T-ETH, PM5072-T-2ETH) to display
the states of the inputs and outputs.
Processor
module
LED State Color LED = ON LED = OFF
PM5012-x-ETH I0..I5 Digital input Yellow Input is ON Input is OFF
O0..O3 Transistor
output
Yellow Output is ON Output is OFF
NO0..NO3 Relay output Yellow Output is ON Output is OFF
PM5032-x-ETH
PM5052-x-ETH
I0..I11 Digital input Yellow Input is ON Input is OFF
O0..O7 Transistor
output
Yellow Output is ON Output is OFF
NO0..NO5 Relay output Yellow Output is ON Output is OFF
User configu-
rable LEDs
I/O LEDs
Processor modules > PM50xx
2021/06/29 3ADR010635, 2, en_US 73
To Next Page
Loading...
