EasyManua.ls Logo

ABB AC500-eCo V3 - TA5142-RS485 RS-485 Serial Adapter (Non-Isolated)

ABB AC500-eCo V3
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.2.6 TA5142-RS485 - RS-485 serial adapter non isolated option board
1 2 LEDs for communication state display (TxD and RxD)
2 2 LEDs for termination state display
3 Allocation of signal name
4 5-pin terminal block for communication interface
6.2.6.1 Intended purpose
Serial communication option board TA5142-RS485 is equipped with 1 RS-485 (2-wire half-
duplex) serial interface which can be used for communication via Modbus RTU or
CAA SerialCom.
Bus terminations are built-in and configurable.
6.2.6.2 Electrical connection
6.2.6.2.1 Seriel interfaces
NOTICE!
Damage to the serial communication interface by using 5-pin terminal
block of the TA5101-4DI!
If the 5-pin terminal block of the TA5101-4DI option board is plugged into a
serial communication option board TA5141-RS232I, TA5142-RS485I or
TA5142-RS485, the communication interface will be damaged by the 24 V.
Please do not confuse the 5-pin terminal block of the TA5101-4DI with the 5-pin
terminal block for serial communication interface of TA5141-RS232I, TA5142-
RS485I or TA5142-RS485.
Device specifications
Option boards > TA5142-RS485 - RS-485 serial adapter non isolated option board
2021/06/293ADR010635, 2, en_US134

Table of Contents

Related product manuals