EasyManua.ls Logo

ABB AC500-eCo V3 - TA5130-KNXPB KNX Address Switch Option Board

ABB AC500-eCo V3
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.2.8 TA5130-KNXPB option board for KNX address switch
1 State LED
2 Allocation of signal name
3 Connector
6.2.8.1 Intended purpose
This option board is only intended to be used with PM5072-T-2ETH(W).
This option board can only be used once on one slot at a time!
The option board is not supported by other AC500-eCo V3 PLCs.
Information can be found in the chapter system technology: see
6.2.8.2 Functionality
Information can be found in the chapter system technology: see
6.2.8.3 Ordering data
Part no. Description Product life cycle phase *)
1SAP 187 200 R0001 TA5130-KNXPB: AC500, KNX
address switch option board, 1 push
button
Active
Device specifications
Option boards > TA5130-KNXPB option board for KNX address switch
2021/06/29 3ADR010635, 2, en_US 141

Table of Contents

Related product manuals