EasyManua.ls Logo

ABB AC500-eCo V3 - Use the Onboard IOs as Output PWM (Pulse-Width Modulation)

ABB AC500-eCo V3
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8.3.8 Use the onboard I/Os as output PWM (pulse-width modulation)
8.3.8.1 Parameter configuration
The user can configure the following output channels as PWM (pulse-width modulation).
“PWM 0”: Output channel 0
“PWM 1”: Output channel 1
“PWM 2”: Output channel 2
“PWM 3”: Output channel 3
“PWM 4”: Output channel 4
“PWM 5”: Output channel 5
“PWM 6”: Output channel 6
“PWM 7”: Output channel 7
See also the following chapter:
8.3.8.2 Function block
The complete cycle of the “PWM” is based on the “OnTime” and “OffTime”.
Simple motion
System technology > Use the onboard I/Os as output PWM (pulse-width modulation)
2021/06/29 3ADR010635, 2, en_US 187

Table of Contents

Related product manuals