Drive module of frame size R8
38
16 Fasten the RDCU Drive Control
Unit. See RDCU Drive Control
Unit Hardware Manual
[3AFE64636324 (English)].
Fasten a terminal for grounding
the control cable shields and self-
adhesive strain reliefs.
17 Fasten the clear plastic vertical busbar shroud on the output busbars of the drive module.
Step Instruction Photo
Self-adhesive
strain relief
Terminal for
grounding of
the control
cable shields
Strain relief
clamp
B
a
s
e
p
l
a
t
e
105 (4.13)
184 (7.24)
Control cable route
Vertical busbar shroud fastened
Note: Remove the protective film from
the shroud surfaces.
Cut the corner
piece to make
space for the PE
terminal of the
drive module.
When connecting the power cables, remove the
front (and top and side) shroud by undoing the
fastening screws.
To Next Page
Loading...
