Technical data
131
Materials
Cabinet Hot-dip zinc coated 1.5 mm thick steel sheet (thickness of coating approximately 20
micrometres). Polyester thermosetting powder coating (thickness approximately 80
micrometres) on visible surfaces. Colour RAL 7035 light beige semigloss.
Busbars Tin-plated copper
Fire safety of materials
(IEC 60332-1)
Insulating materials and non-metallic items mostly self-extinctive
Package Wood. Plastic covering of the package: PE-LD, bands PP or steel.
Disposal The drive contains raw materials that should be recycled to preserve energy and natural
resources. The package materials are environmentally compatible and recyclable. All
metal parts can be recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations. Most recyclable parts are marked
with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit
boards can be landfilled. The DC capacitors (C1-1 to C1-x) contain electrolyte and the
printed circuit boards contain lead, both of which are classified as hazardous waste within
the EU. They must be removed and handled according to local regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
Applicable standards
The drive complies with the standards below. The compliance with the European Low
Voltage Directive is verified according to standards EN 61800-5-1 and EN 60204-1.
• IEC/EN 61800-5-1:2007 Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy
• EN 60204-1:2006 +
A1:2009
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
emergency-stop device.
• EN 60529:1991 Degrees of protection provided by enclosures (IP code)
• IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
• EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
• UL 508C (2002) UL Standard for Safety, Power Conversion Equipment, second edition
• UL 508A (2001) UL Standard for Industrial Control Panels, first edition
• NEMA 250 (2003) Enclosures for Electrical Equipment (1000 Volts Maximum)
• CSA C22.2 No. 14-10:2010 Industrial control equipment
To Next Page
Loading...
