Advant Controller 450 Product Guide
Section 4.8.2 Fieldbus Communication
3BSE 015 953R201 Rev B 4-9
PROFIBUS-DP
NOTE
The bus must be terminated at its ends. By selecting a connector with built-in
termination this can be done conveniently.
NOTE
Field devices using the PROFIBUS-PA protocol can be connected to Advant
OCS’s PROFIBUS-DP solution via the external segment couplers
KFD2-BR-Ex1.PA or KFD2-BR-1.PA from the company Pepperl+Fuchs, GmbH.
L
ONWORKS Network Interface
NOTE
The bus termination differs depending on used bus topology.
See Advant Interface to L
ONWORKS User’s Guide for further information.
Figure 4-9. PROFIBUS-DP connected to Advant Controller 450
Figure 4-10. L
ONWORKS connected to Advant Controller 450
AC 450
SC510 or SC520
CI541V1
AC 450
SC510 or SC520
CI572
To Next Page
Loading...
