30 Installation Guide
—
Figure 13 CoreSense dashboard
5 Click on the Settings tab to configure communication settings (see “Administration settings” on
page 36.
6 Set the system ID to label each specific CoreSense.
7 Set the system date.
8 Modify your password.
9 Configure communication settings, i.e. RS-485 configuration, TCP configuration, 4–20 mA output
configuration (see “Communication settings” on page 37).
10 Enable the thermal pump.
NOTICE
When enabling the thermal pump, the CoreSense must be properly connected and it
must contain oil. Make sure there are no oil leaks.
To Next Page
Loading...
