—
CHAPTER 5
Configuring the sensor head
You can configure the sensor head once it has been properly installed in the transformer. The following
pages explain the proper method to do so.
Connecting a laptop for the first time
The first time you connect a laptop to your system:
1 Power up your laptop.
2 Connect the laptop to the service Ethernet port using a straight Ethernet cable. For the location of
the Ethernet port, see Figure 3 “CoreSense port and relay connections” on page 21.
The sensor service Ethernet port is configured as a DHCP server and will assign a valid IP address
automatically to your laptop.
NOTICE
Do not connect your internal network to the SERVICE port.
3 Start up your web browser (recommended: Internet Explorer 9 or above).
4 Direct your web browser to http://172.16.100.1 to connect to the web interface.
To Next Page
Loading...
