36 Installation Guide
Administration settings
The Administration settings tab allows to modify and/or set several analyzer or administrative
settings. Accessing the Administration settings dialog box requires the administrator password.
—
Figure 20 Administration settings dialog box
Analyzer settings
• Device ID: configurable field to label a sensor.
• Analyzer date/time: enter local time.
• Use NTP server: click to activate and enter address of NTP server.
General Settings
The General Settings section allows you to set or modify the active passwords.
Network Settings
The Network Settings section allows your to configure the SCADA and service Ethernet ports. Both
ports can be DHCP enabled. See Figure 3 “CoreSense port and relay connections” on page 21 for the
location of the SCADA and service Ethernet port.
Misc.
• Enable ABB diagnostics remote access: when checked, allows an ABB user to access special
diagnostics.
• Enable Settings on SCADA Port: when unchecked, the settings section of the web interface will not
be accessible using the SCADA port.
• Enable Thermal Pump: when checked, allows the oil to be circulated to the sensor. When the thermal
pump is not enabled, the system LED is yellow.
To Next Page
Loading...
