ABB DPA Upscale RI Series - Customer Interface and DRY Ports (Volt-Free Contacts); Output Interfaces Terminal Blocks X2 (DRY Ports); Input Interfaces Terminal Blocks X1

Section-3
04-3006_S3_OPM_ABB_DPA_UPSCALE_RI_10-80kW_EN_150316.doc Page 3/4 ABB
Modifications reserved
3.1.1 Customer interface and DRY PORTs (volt-free contacts)
All the Input and Output interfaces are connected to Phoenix terminals (cable 0.5 mm2)
3.1.1.1 Output Interfaces Terminal blocks X2 (DRY PORTs)
 Provision of signals for the automatic and orderly shutdown of servers, AS400 or Automation building systems
3.1.1.2 Input Interfaces Terminal blocks X1
 Connection of Remote Shut down facilities, Generator Operation, Customers specials (see Section 9, chapter 1.2 OPTIONS)
All voltage free contacts are rated 60 VAC max. and 500 mA max.:
Block
Terminal
Contact
Signal
On Display
Function
X2
X2 / 1
NO
MAINS_OK
Mains Present
X2 / 2
NC
ALARM
Mains Failure
X2 / 3
C
Common
X2 / 4
NO
LOAD_ON_INV
Load on Inverter
X2 / 5
NC
Message
(Load on Mains bypass)
X2 / 6
C
Common
X2 / 7
NO
BATT_LOW
Battery Low
X2 / 8
NC
ALARM
Battery OK
X2 / 9
C
Common
X2 / 10
NO
LOAD_ON_MAINS
Load on bypass (Mains)
X2 / 11
NC
Message
(Load on Inverter)
X2 / 12
C
Common
X2 / 13
NO
COMMON_ALARM
Common Alarm (System)
X2 / 14
NC
ALARM
NO Alarm Condition
X2 / 15
C
Common
X1
X1 / 1
IN
+ 12Vdc
Generator Operation
X1 / 2
GND
GND
(NC = Generator ON)
X1 / 3
IN
+ 12Vdc
Customer IN 1
X1 / 4
GND
GND
(Function on request, to be defined)
X1 / 5
IN
+
3.3Vdc
Temperature Battery
X1 / 6
GND
GND
(If connected , the battery charger current if depending of the battery temp.)
X1 / 7
IN
+ 12Vdc
Remote Shut down
X1 / 8
GND
GND
(Do not remove the factory mounted bridge until external Remote Shut down
is connected)
X1 / 9
IN
+ 12Vdc
12 Vdc sourse
X1 / 10
GND
GND
(max. 200 mA load)
Phoenix Spring Terminals (X1…X2) Connection