Section-3
04-3006_S3_OPM_ABB_DPA_UPSCALE_RI_10-80kW_EN_150316.doc Page 4/4 ABB
Modifications reserved
3.1.2 JD1 / RS232 Smart Port Computer Interface
The Computer Interface JD1 (4) located on the distribution part is an intelligent RS 232 serial port that allows
the UPS system to be connected to a computer. The connector JD1 is a standard D-Type, 9-pin, female.
When installed the Computer Interface, the optional WAVEMON software allows the computer to monitor the
mains voltage and the UPS system status continuously.
In the event of any changes the computer terminal will display a message.
(For details see our optional Monitoring Package: WAVEMON).
3.1.3 USB Computer Interface
The Computer Interface USB (5) located on the distribution part and is in parallel with the intelligent
RS 232 serial port JD1.
When installed the USB Computer Interface trough, the optional WAVEMON software allows the computer to
monitor the mains voltage and the UPS system status continuously.
In the event of any changes the computer terminal will display a message.
(For details see our optional Monitoring Package: WAVEMON).
Example : Distribution Interfaces
1 JR2 / RS485 (Not used ) foreseen for RJ45 Plug
2 X2 Customer interface on Phoenix Terminals
= Potential free contacts
X1 Customer Inputs
(detail see Section 3 / 1.2 )
3 LED red /green
4 JD1 Smart Port RS232 / Sub D9/ female,
PC interface
5 USB PC Interface
6 SNMP Slot for optional SNMP card ONLY
7 Modem Slot for optional Modem/Ethernet card ONLY
To Next Page
Loading...
