EL3000 CONTINUOUS GAS ANALYZERS | CI/EL3000-EN REV. C 119
Returning devices
Use the original packaging or a secure transport container of an
appropriate type if you need to return the device for repair or
recalibration purposes.
Fill out the return form (see Return form on page 121) and
include this with the device.
In accordance with the EU Directive governing hazardous
materials, the owner of hazardous waste is responsible for its
disposal or must observe the following regulations for shipping
purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Address for the return:
ABB Automation GmbH
Service Analysentechnik – Parts & Repair
Stierstädter Straße 5
60488 Frankfurt, Deutschland
Fax: +49 69 7930-4628
E-Mail: repair-analytical@de.abb.com
www.abb.de/prozessautomatisierung-service
10 Recycling and disposal
Note
Products that are marked with the adjacent symbol
may
not be disposed of as unsorted municipal waste
They should be disposed of through separate
collection of electric and electronic devices.
This product and its packaging are manufactured from materials
that can be recycled by specialist recycling companies.
Bear the following points in mind when disposing of them:
• As of 8/15/2018, this product will be under the open
scope of the WEEE Directive 2012/19/EU and relevant
national laws (for example, ElektroG - Electrical
Equipment Act - in Germany).
• The product must be supplied to a specialist recycling
company. Do not use municipal waste collection points.
These may be used for privately used products only in
accordance with WEEE Directive 2012/19/EU.
• If there is no possibility to dispose of the old equipment
properly, our Service can take care of its pick-up and
disposal for a fee.
To Next Page
Loading...
Need help?
General
